SCH-ZJ18FN-B Small medium power relay

ZJ18FN-B Small medium power relay

ZJ18FN-B Small high-power relay, small size, easy to install, high sensitivity，Relays with AC and DC coils have different colors of operating indicators (LEDs)，UL, CE, and TüV certification.

Ratings and Specifications

Operating coi
ltem		Rated current		Coil resistance	Coil inductance		Must-operatevoltage	Must-release voltage	Maximum voltage	Power consumption
Rated voltage		50Hz	60Hz		Armature OFF	Armature ON	Percentage of rated voltage
AC	24	53.8	46	180	0.69	1.3	80%below¹	30%以上2	100%	约1.1(60Hz)   约0.9～1.1   (60Hz)
	100/110	11.7/12.9	10.0/11.0	3750	14.54	24.6
	200/220	6.2/6.8	5.3/5.8	12950	54.75	94.07
	220/240	5.2/6.2	4.3/5.0	15920	83.5	136.4
DC	24	36.3(37.7)		662(636)	3.2	5.72		1 0 % 以 上		约0.9

Note:

1.The rated current and coil resistance are measured at a coil temperature of 23°C with tolerances of+15%/-20%for the AC rated currentand +15%for the DC coilresistance.

2.The AC coil resistance and inductance values are reference values only (at 60 Hz).

3.Operating characteristics were measured at a coil temperature of 23°C.

4.The values in parentheses for the rated currents and coil voltages of DC coils are for models with LED operation indicators.

5.The maximum voltage capacity was measured at an ambient temperature of 23°C.

*1.There is variation between products,but actual values are 80%max.The Relay will operate if 80%or higher of the rated voltage is applied.However,to achieve the specified characteristics,apply the rated voltageto the coil.

*2.There is variation between products,but actual values are 30%minimum for AC and 10%minimum for DC.To ensure release,use a valuethat is lower than the specified value.

Contacts

*These values are guides for the switchable limits for minute load levels,such as in electronic circuits.Actual characteristics may be different.

These values will depend on the switching frequency,atmosphere,and expected reliability level.Confirm applicability in the actual system under actual application conditions.

     *1.Measurement conditions:1 A at 5 VDC using the voltage drop method.

     *2.Measurement conditions:With rated operating power applied,not including contact bounce time.

     *3.Measurement conditions:For 500 VDC applied to the same location as for dielectric strength measurement.

     *4.Ambient temperature

Product Display